2026-05-31 13:46 UTC
Another weekend, another #diy #cnc fun.
The touch probe stopped working after I moved the screen to another side of the machine. Why? Let's look at the wonderful "grbl board" from (sc)amazon I use. To be more precise, at the yellow headers at the bottom. Both limits and probe seemingly work the same way: pull the pin to the conventient ground nearby and you get a trigger. Buuuuuut those grounds aren't the same! The 4 optocouplers near the limit header could give a hint...
The 24V side was properly grounded to the frame of the machine. And the low voltage was grounded via... usb cable -> raspberry -> hdmi cable -> display -> mount brackets -> frame. T-nut in 2020 profile is a shitty electrical connection, so I guess after moving the screen it wasn't ground enough anymore.
4 days of waiting for the (unneeded) replacement board and one jumper wire later everything works again.
Replies (0)
No replies.